PLANET WNAP-7206 - Manual (Page 18)

User Manual of WNAP-7206
-10-
Figure 2-4 Warning label
Interface Function
RP-SMA Connector
For external antenna. You can use the RP-SMA connector to connect
with 5GHz external antenna.
LAN
The RJ-45 sockets allow LAN connection through Category 5 cables.
Support auto-sensing on 10/100M speed and half/ full duplex; comply
with IEEE 802.3/ 802.3u respectively.
Reset
There are two ways to reset the AP’s factory defaults:
 Use the Factory Defaults function: on System Tools -> Factory
Defaults page in the AP’s Web-based Utility.
 Use the Factory Default Reset button: Press and hold the Reset
button until Wireless Signal Strength LEDs flash, and then the AP
will reboot.
1. For External Antenna Mode, you MUST physically attach antenna before power
on.
2. For using external antenna, you should configure the Antenna Switch from
“Internal” to “External” via Web UI.
2.1.3 PoE Injector
Figure 2-5 Top view of PoE Injector