PLANET WNAP-7206 - Manual (Page 114)

User Manual of WNAP-7206
-106-
Figure 5-8-2-1 Port Triggering
To add a new rule on the Port Triggering screen:
1. Click the Add New... button.
2. Enter a port number used by the application to send an outgoing request in the Trigger Port box.
3. Select the protocol used for the Trigger Port from the pull-down list of Trigger Protocol, either TCP, UDP, or
All.
4. Enter the range of port numbers used by the remote system when it responds to the PC's request in the
Incoming Ports box.
5. Select the protocol used for Incoming Ports range from the pull-down list, either TCP, UDP, or All.
6. Select the Enabled option in the Status pull-down list.
7. Click the Save button to save the new rule.
The page includes the following fields:
Object Description
 Trigger Port
The port for outgoing traffic. An outgoing connection using this port
will Trigger this rule.
 Trigger Protocol
The protocol used for Trigger Ports, either TCP, UDP, or All (all
protocols are supported by the Device.).