PLANET SGS-5220-24T2X - Manual (Page 283)

Command Guide of SGS-5220-24T2X
GigabitEthernet 1/1 :
---------------------
GigabitEthernet 1/1 access-list action is permit
GigabitEthernet 1/1 access-list policy ID is 0
GigabitEthernet 1/1 access-list rate limiter ID is disabled
GigabitEthernet 1/1 access-list redirect is disabled
GigabitEthernet 1/1 access-list logging is disabled
GigabitEthernet 1/1 access-list shutdown is disabled
GigabitEthernet 1/1 access-list port-state is enabled
GigabitEthernet 1/1 access-list counter is 0
4.20.5 show access-list ace-status
Command:
show access-list ace-status [ static ] [ link-oam ] [ loop-protect ] [ dhcp ] [ ptp ]
[ upnp ] [ arp-inspection ] [ mep ] [ ipmc ] [ ip-source-guard ] [ ip-mgmt ] [ conflicts ]
[ switch ]
show Show running system information
access-list Access list
arp-inspection The ACEs that are configured by ARP Inspection module
conflicts The ACEs that did not get applied to the hardware due to hardware limitations
dhcp The ACEs that are configured by DHCP module
ip-source-guard The ACEs that are configured by IP Source Guard module
ipmc The ACEs that are configured by IPMC module
link-oam The ACEs that are configured by Link OAM module
loop-protect The ACEs that are configured by Loop Protect module
mep The ACEs that are configured by MEP module
ptp The ACEs that are configured by PTP module
static The ACEs that are configured by users manually
upnp The ACEs that are configured by UPnP module
Default:
N/A
Usage Guide:
To display the ACE Status.
Example:
To display the ACE Status.
-283-