PLANET SGS-5220-24T2X - Manual (Page 126)

Command Guide of SGS-5220-24T2X
4.2.45.103 speed
Command:
speed [10 | 100 | 1000 | 10g | auto]
speed Configures interface speed. If you use 10, 100, or 1000 keywords with the auto keyword the port will only
advertise the specified speeds.
10 10Mbps
100 100Mbps
1000 1Gbps
10g 10Gbps
auto Auto negotiation
Default:
Auto
Usage Guide:
To configure line speed for specific interface
Example:
To configure line speed (1Gbps) for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # speed 1000
4.2.45.104 switchport access vlan
Command:
switchport access vlan
switchport Switching mode characteristics
access Set access mode characteristics of the interface
vlan Set VLAN when interface is in access mode
VLAN ID of the VLAN when this port is in access mode
Default:
1
Usage Guide:
To configure access VLAN ID for specific interface
Example:
To configure access VLAN ID (5) for GigabitEthernet X/X
-126-