KEPCO KLR Series User Manual - Manual (Page 18)

1-6
KLR 091313
PROGRAMMING CHARACTERISTICS - ANALOG
Analog remote control selection Activate with jumper at analog program-
ming connector
Recognized during power up.
isolation Safety Extra Low Voltage (SELV)
Analog Input Update Rate 2Hz (0.5 Second) Applies to program-
ming by voltage/ resistance and read-
back specifications. Analog input voltage digitized (12-bit
resolution), optically isolated, then pro-
cessed by digital section.
Programming by voltage voltage 0-10V See PAR. 4.3.3 to reduce Full Scale
voltage.
current 0-10V Min. programming limit; see Table 1-2.
See PAR. 4.3.3 to reduce Full Scale
voltage.
Programming by resistance voltage 0-10K Ohms See PAR. 4.3.3 to reduce Full Scale
resistance.
current 0-10K Ohms Min. programming limit; see Table 1-2.
See PAR. 4.3.3 to reduce Full Scale
resistance.
Readback 0-10V proportional signal Proportional to analog control volt-
age/resistance.
Remote inhibit TTL compatible Dual polarity; see PAR. 3.2.17.3.1.
Composite status flag Isolated form C contacts Programmable functions (PAR.
3.2.17.1).
PROGRAMMING CHARACTERISTICS - DIGITAL
Supported Interfaces standard models GPIB and RS 232 SCPI command set for GPIB and RS
232 (see KLR Developer’s Guide).
E-Series models GPIB and LAN Support SCPI command set (see KLR
Developer’s Guide) for GPIB and LAN;
Support four interfaces for LAN:
1. Web interface, port 80
2. SCPI Telnet, port 5024
3. SCPI Sockets, port 5025
4. VXI 11, port 1024
GPIB GPIB address range: 1 to 30 Factory default is 6.
RS 232 standard models Baud Rate range: 2400, 4800, 9600,
19,200 or 38,400
Factory default is 38,400.
Digital remote control isolation Safety Extra Low Voltage (SELV)
format compatible with SCPI protocols W98 SE and later operating systems.
Programming resolution 0.024% of Emax and Imax
Programming accuracy 0.05% of Emax and Imax
Readback resolution 0.024% of Emax and Imax
Readback accuracy 0.1% of Emax and Imax
Status reporting OVP, OCP, OTP, output lead fault
(OLF), fan failure, power loss See PAR. 1.5.4 and 1.5.9.
TABLE 1-3. KLR SPECIFICATIONS (Continued)
SPECIFICATION RATING/DESCRIPTION CONDITION/COMMENT