TA Triumph-Adler 3060i User Manual
Page 457
10-27
Troubleshooting > Troubleshooting
S
T
Message
Checkpoints
Corrective Actions
Reference
Page
Scanner memory is full.
*
*
When Auto Error Clear is set to [On], processing resumes automatically after a set amount of time elapses.
—
Scanning cannot be performed due
to insufficient memory of the
scanner. Follow the instructions on
the screen.
—
Send Error.
*
—
An error has occurred during
transmission. The job is canceled.
Press [End]. Refer to Responding to
Send Error for the error code and
corrective actions.
Skewed originals fed.
―
See the caution attached on the
document processor and check the
originals. If the originals are
jammed, follow the instructions on
the screen to remove the originals.
―
Staple is empty. (Manual
Staple)
Has staple cartridge holder A run
out of staples?
Add staples to staple cartridge
holder A.
Staple is empty.
*
Has the staple cartridge holder run
out of staples?
If the staples are depleted, the
machine will stop and the location of
staple depletion will be indicated on
the screen. Leave the machine on
and follow the instructions to
replace the staple case. Press
[Continue] to print without stapling.
Press [Cancel] to cancel the job.
Staple jam.
—
If a staple jam occurs, the machine
will stop and the location of the jam
will be indicated on the screen.
Leave the machine on and follow
the instructions to remove the
jammed staple.
System error.
—
System error has occurred. Follow
the instructions on the screen.
—
Message
Checkpoints
Corrective Actions
Reference
Page
The cover is open.
Is there any cover which is open?
Close the cover indicated on the
screen.
―
The password does not
meet password policy.
Is the password expired?
Change the login password.
The job is canceled. Press [End].
Is the password policy requirement
(such as password length or
required characters) changed?
Confirm the password policy
requirements and change the login
password.
The job is canceled. Press [End].