TA Triumph-Adler 2500ci - Manual (Page 178)

5-4
Operation on the Machine > Loading Originals
1 Adjust the original width guides.
2 Place the originals.
Put the side to be scanned (or the first side of two-sided originals) face-up. Slide the leading
edge into the document processor as far as it will go. The original loaded indicator lights when
the original is placed correctly.
NOTE
For details on Original Orientation, refer to Original Orientation on page 6-16 .
IMPORTANT
Confirm that the original width guides exactly fit the originals. If there is a gap,
readjust the original width guides. The gap may cause the originals to jam.
Ensure that loaded originals do not exceed the level indicator. Exceeding the
maximum level may cause the originals to jam.
Originals with punched holes or perforated lines should be placed in such a way that
the holes or perforations will be scanned last (not first).
Original placement
indicator