RIGOL DSA875 - Manual (Page 57)

Chapter 10 To Perform Final Scan RIGOL
User’s Guide for EMI Test System 10-1
Chapter 10 To Perform Final Scan
Click Final Scan in the main interface of the software (Figure 3-1) and the
software starts to perform final scan. At this point, the software scans the signal
under measurement according to the final scan parameters edited in Edit Scan
and displays the final scan progress bar in the spectrum window as shown in the
figure below.
Figure 10-1 Final Scan Interface
After the final scan is performed, the measurement results are displayed in the
Final Level(dBm) column in the Peak search list.
Note: You can only perform final scan after peak search is performed; otherwise,
Final Scan is grayed out and disabled.