RIGOL DSA875 - Manual (Page 53)

Chapter 9 To Perform Peak Search RIGOL
User’s Guide for EMI Test System 9-3
To Edit the Peak Search List
The Peak search list is displayed at the bottom of the main interface of the
software (Figure 3-1). You can edit the list data using the Peak list editing
buttons.
1. Add peak data
After performing peak search,
 Click Add Peak and the dialog box as shown in the figure below is
displayed.
Click the Frequency(Hz) box in the figure above and input the desired
frequency. The default unit is Hz. Then, click Add to search the amplitude
corresponding to the frequency point and add the search result into the
peak search list (it is added into the last row by default).
 Click Insert Before to insert a group of peak data in the row in front of
the data row currently selected. For how to insert peak data, refer to the
introduction of Add Peak.
 Click Insert After to insert a group of peak data in the row behind the
data row currently selected. For how to insert peak data, refer to the
introduction of Add Peak.
2. Delete peak data
 Select a row of data in the peak search list and click Delete Peak to
delete the peak data in the specified row.
 Click Clear Peak to delete all the data in the peak search list.
3. Add comment information
Click Comment and the Add Comment dialog box is displayed as shown in
the figure below.