RIGOL DSA875 - Manual (Page 39)

Chapter 6 To Set the Scan Parameters RIGOL
User’s Guide for EMI Test System 6-1
Chapter 6 To Set the Scan Parameters
Click Edit Scan in the main interface of the software (Figure 3-1) to open the scan
parameter editing interface as shown in the figure below.
Figure 6-1 Scan Parameter Editing Interface
Subjects in this chapter:
 To configure the Pre-scan Parameters
 To Configure the Segment Scan Parameters
 To Configure the Final Scan Parameters
Tip:
(1) The parameter ranges introduced in this section are related to the model of the
spectrum analyzer used.
(2) When setting a parameter, the software will automatically use the limit value
(upper limit value or lower limit value) and no prompt message will be
displayed if the parameter set exceeds the limit value (greater than the upper
limit value or lower than the lower limit value).
Scan list Scan list editing buttons