To select correction factor(s), To enable the correction function – RIGOL DSA875 User Manual
Page 37
Chapter 5 To Edit the Amplitude Correction Data
RIGOL
User’s Guide for EMI Test System
5-3
4. Save the data list
Click Save to save the correction data edited in csv format.
5. Load a data list
Click Load to load a stored correction data csv file.
To Select Correction Factor(s)
After editing the correction data, click the Correction factor checkboxes to
select the desired correction factor(s) (Antenna, Cable, Other or User).
Check the checkbox to select the corresponding correction factor. Uncheck the
checkbox to unselect the corresponding correction factor.
Tip:
You can select one, more or all of Antenna, Cable, Other and User as the
correction factors.
To Enable the Correction Function
After selecting the desired correction factor(s), you can click Correction to enable
the correction function(s) of a single, more or all of the correction factors. At this
point, the status icon of the spectrum analyzer is turned on and the amplitude
correction function of the analyzer is enabled.