RISCO Group axesplus® - Manual (Page 38)

User Manual for Hardware Installation
Uncontrolled when printed © RISCO Group 37
Figure 26: Card Address Switch
As you can connect two ACIBs to one ACCB, you need to identify which are ACIB 1 and ACIB 2. So
whenever you switch ON the switch number 1 of the Card Address Switch, this ACIB is considered to
be ACIB2 otherwise it is considered to be ACIB1. If the SW6-1 is on, the ACIB will control the door 3
and 4. If SW6-1 is off, it controls door 1 and door 2.
6.10 Push Button – Factory Reset
Push Button on the ACIB can be used to factory reset the ACCB. Factory reset will delete all the data
on the ACCB. If the ACCB is not connected to the proxy, then it will go into programming mode.
Refer to
5.4 Installation/Programming Mode for ACCB
.