RISCO Group axesplus® User Manual

Page 24

User Manual for Hardware Installation

Uncontrolled when printed

Add Cards to the ACCB Database

Perform the following steps:

1. Swipe the master card on the reader. The readers again start blinking.
2. Swipe the card for which access should be granted.
3. Swipe any other card which will be considered as an associate card for the card which

needs access. The readers stop blinking and the card gets added to the internal database of
the ACCB. The second card (added to the database) will be provided access henceforth. The
same associate card can be associated with a group of cards that need to get access.

This associate card will be used to erase the two cards (access granted card and associated card)

from the memory and must be carefully stored. For deleting cards,

see

Delete a Card from ACCB

Note: Between two continuous card swipes, there should not be a gap of more than 10 seconds.

This mode will work only when there is no configuration in the ACCB.

Ensure that the same card is not used as a Master Card and Associate Card.

Note: REX button can be used to grant access in this mode both before and after the master card is

created.

This process can also be replicated with a Personal Identification Number (PIN), where you can type

a PIN as a Master Card, Associate Card or the PIN which needs access.

Delete a Card from ACCB

To delete a card that is added to the ACCB database:

1. Swipe the master card.
2. Swipe the associate card (associated with the card you want to delete). The card is deleted

from the database and will not be granted access henceforth.

Warning:

If the associate card is associated with multiple cards, then all the cards are

deleted from the ACCB database