Precision Digital PD6310 - Manual (Page 96)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
96
Display Parameter Action/Setting Description
Lit Lo Min on Lower
display
Assign digital input to display min on the
Lower display
Little Lower display
To assign the Lower display parameters
locd Locked
Enter password to unlock controller
Lo spd Low Speed Filter
Program Low Speed Filter
Lt-CLr Latching-cleared
Set relay for latching operation with manual
reset only after alarm condition has cleared
(relays assigned to rate)
mA 4-20 mA
Set controller for 4-20 mA input
mAn Manual
To manually control
mAx Maximum
Program maximum mA output allowed
mbus Modbus
Select to display Modbus input or to assign
Modbus input as the analog output source
menu
Menu button
Assign digital input to Menu button
min Minimum
Program minimum mA output allowed
No PtS Number of points
Set controller for 2 to 32-point linearization
nonrst Non-resettable
Non-resettable grand total set after entering
“050873” for Gtotal password
O Hold
Relays output
hold
Assign digital input to hold all relays state
OFF Off
Disable relay and front panel status LED,
turn relays off, program off time delay
OFF 1 Off
Set relay 1 Off time delay
On
On
Enable fail-safe operation, turn relays on,
program on time delay
On 1 On
Set relay 1 On time delay
O-rang
Overrange
Program mA output for display overrange
Out 1 Output 1
Program output 1 value (e.g. 4.000 mA)
Out 2 Output 2
Program output 2 value (e.g. 20.000 mA)
pass
Password
Enter the Password menu
Pass 1 Password 1
Set or enter Password 1