Precision Digital PD6310 - Manual (Page 75)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
75
Display Parameter Action/Setting
Aoutpr Analog output
programming
Analog output programming
seriAl Serial
Set serial communication parameters
LED t
LED test
Test all LEDs
Info Information
Display software information
Function Keys Operation
During operation, the programmable function keys operate according to
the way they have been programmed in the Advanced Features – User
menu. The following table shows the default setting for each of the
function keys.
Function Key/Button Default Setting Action
F1/START Start Start batch
F2/BATCH preset Change preset
F3/STOP stop Pause/stop batch
F4/Digital Input Srtstp Start/stop batch
F4 Operation
A digital input, F4, is standard on the meter. This digital input is
programmed identically to function keys F1, F2, and F3. The input is
triggered with a contact closure to COM, or with an active low signal.
During operation, F4 operates according to the way is has been
programmed in the Advanced Features – User menu.
!
Only STOP Operation Enabled if a Batch is Running.
During a batch process, the only function that can be
performed is the pause/stop functions of the STOP button;
the default programming of the F3 key. No other functions,
including min/max display, manual alarm reset, or total
reset, will function while a batch is running.
Advanced Setup and Calibration
Multi-Point Calibration & Scaling
The controller is set up at the factory for 2-point linear calibration. The
number of points for multi-point calibration/scaling is set up in the
Advanced
Features menu. Up to 32 linearization points may be selected.
See page 79 for details.