Precision Digital PD6310 - Manual (Page 39)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
39
Display Functions and Messages
The controller displays various functions and messages during setup,
programming, and operation. The following table shows the main menu
functions and messages in the order they appear in the menu.
Display Parameter Action/Setting Description
setup Setup
Enter Setup menu
Input Input
Enter Input selection menu
volt 0-10 VDC PD6210 Only: Set input for ±10 VDC input
mA 4-20 mA
PD6210 Only: Set input for 4-20 mA input
Total Total
Enable or disable totalizer features
unitS Units
Select the display units/tags
rate Rate
Select the display units for rate
total Total
Select the display units for total
Gtotal Grand Total
Select the display units for grand total
Dec pt Decimal point
Set decimal point for rate, total, grand total
prog Program
Enter the Program menu
InCAL Input Calibration
Enter the Input Calibration menu
factor K-factor
Scaling
PD6310 Only: Programs unit to convert
input pulse to rate in engineering units
sCalE Scale
Enter the Scale menu
Cal Calibrate
Enter the Calibrate menu
Inp 1 Input 1
Calibrate input 1 signal or program input 1
value
Dis 1 Display 1
Program display 1 value
Inp 2 Input 2
Calibrate input 2 signal or program input 2
value (up to 32 points)
Dis 2 Display 2
Program display 2 value (up to 32 points)
Error Error
Error, calibration not successful, check
signal or programmed value
T tb Total time base
Enter totalizer time base for seconds,
minutes, hours or day.
T Cf
Total conversion
factor
Enter the conversion factor decimal point
and the conversion factor.