Precision Digital PD6310 - Manual (Page 86)

Model PD6210 & PD6310 Batch Controllers Instruction Manual
86
Reset Controller to Factory Defaults
When the parameters have been changed in a way that is difficult to
determine what’s happening, it might be better to start the setup process
from the factory defaults.
Instructions to load factory defaults:
1. Enter
the
Advanced Features
menu. See ADVANCED OPERATION
AND PROGRAMMING, page 71.
2. Press Up arrow to go to Diagnostics menu
3. Press and hold Right arrow for three seconds, press
Enter when display flashes reset.
Note: If Enter is not pressed within three seconds, the display
returns to the Diagnostics menu.
4. The controller goes through an initialization sequence (similar as on
power-up), and loads the factory default settings.