MCZ PowerBox COMPACT - Manual (Page 44)

Chapter 4
INSTALLATION AND USE MANUAL
page
44
Operation Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
PHASE 7 PHASE 8
4
PROGRAM
24 h
5
PROGRAM
24 h
After selecting programme 42 for TU=Tuesday,
confirm this choice with button 4 to go on to the
programming of WE= Wednesday. As before, a dash
will light up under TU=Tuesday and the symbol
WE=Wednesday will start flashing.
For WE=Wednesday, no programme is desired.
Therefore, as in the other cases, it is enough to use
button 5 to select programme 00 and then confirm
the selection with button 4.
PHASE 9 PHASE 10 CONCLUSION
6
PROG RAM
24 h
Since no programme has been set for WE=
Wednesday (it was decided to select 00), you will
note that programming moves to TH= Thursday but
that under the symbol WE=Wednesday there is no
dash. This means that for that day, no timer
programme has been set.
To conclude programming for the remaining days of
Thursday, Friday, Saturday and Sunday, proceed as for
Monday, Tuesday and Wednesday. The only difference is
the programme number which is selected with button 5.
Upon completion of programming of all days, when you
come to SU=Sunday, press button 6 to exit
programming. You can also wait 30 seconds and the
remote control will automatically exit programming,
confirming all settings made. For a quick check of
programming, look to see whether there are dashes
under the symbols of the week, or you can go back to
programming with button 6, re-select programme P99
with key 5, and then, still using button 6, scroll all the
days of the week to check which programme has been
set.
4.15. INSERTION OF KEYPAD LOCK
The remote control is equipped with a function that makes it possible to
lock the keypad, so that keys cannot be pressed accidentally or the
remote control cannot be used by a child.
This lock is activated simply by press button 6 for 5 seconds.
After that time, a lock symbol will appear at the upper left of the
display to confirm that the keys are locked.
To deactivate the lock, repeat the operation described above.
4.16. PELLET LEVEL SENSOR
The pellet hopper contains a sensor that detects when fuel is running
low and prevents the fuel compartment from emptying completely. This
signal consists of 2 beeps repeated every minute and the flashing
message PELLET on the display of the emergency panel. The can only
show 3 characters. Therefore, the message PELLET will two parts:
“PEL” “LET” Î PELLET. In this phase, the stove automatically
goes to minimum power.
To eliminate the signal and restore normal operating conditions, just fill
the hopper with pellets. During the pre-alarm phase, which lasts
about 20 minutes, if the user does not add pellets, the unit will start
MAX
- OFF
- REMOTE
- ON
- MIN
- MED
- MAX
TEST
- OFF
- REMOTE
- ON
- MIN
- MED
- MAX
TEST