MCZ PowerBox COMPACT - Manual (Page 24)

Chapter 4
INSTALLATION AND USE MANUAL
page
24
Operation Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
4. OPERATION
4.1. PRE-LIGHTING WARNINGS
Do not touch the stove during the first lighting, as it
is during this phase that the paint sets. If you touch
the paint, you may expose the steel surface. It is
good practice to provide plenty of ventilation in the
room during the initial lighting, as the stove will give
off a small amount of smoke and smell of paint.
Do not remain near the product and, as previously mentioned, ventilate
the room. The smoke and the smell of paint will vanish after about one
hour of operation. There are no health risks involved.
The structure will be subject to expansion and contraction during the
lighting and cooling down stages, and may therefore make slight
creaking noises.
This phenomenon is absolutely normal, the structure being made of
sheet steel, and must not be considered a fault.
It is extremely important to be sure not to take the stove to full heat
straight away, but to bring it gradually up to temperature.
If in manual mode, use low heating powers (for example 1 a -2 a -3 a ).
During subsequent use, you will be able to make use of all available
heating power (e.g. 4 a -5 a ), but remember not to keep the stove
running on full power for more than 60-90 minutes.
This avoids damages to welds and the steel structure.
At first lighting the stove is already in manual mode.
At first, it is advisable to use the only low and
medium heating levels (from first to third power
level).
Do not demand full heating
performance straight away!
Try to get familiar with commands given from the control panel or
remote control.
Try to memorize the messages that the display of the remote control
provides.
4.2. PRE-LIGHTING CHECK
Check that all the safety conditions described above have been met.
Make sure you have read and completely understood the contents of
this instruction booklet.
Open the door and remove any components which might burn from the
firebox and from the glass (various instructions and adhesive labels).
Check that the grate is positioned correctly and rests firmly on the
base, and that the fire door closes correctly.
Opening of fire door