MCZ PowerBox COMPACT - Manual (Page 33)

Chapter 4
INSTALLATION AND USE MANUAL
page
33
Operation Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
4.9. OPERATING MODE
SOLAR-GEA stoves have two operating modes: MANUAL and
AUTOMATIC.
4.9.1. Manual and automatic
The stove can operate in one of these two different operating modes.
MANUAL mode allows only adjustment of the flame from power 1 to
power 5, ignoring any ambient temperature measurement. This mode
is indicated by the message MAN on the display of the remote control
(icon 1)
AUTOMATIC mode, on the other hand, lets you set the desired
temperature in the room of installation. The stove will control its power
autonomously in order to reach and maintain the established
temperature in the room. This mode is indicated by the message AUTO
on the display of the remote control (icon 1)
With this mode you can also use an advanced function called
ECOSTOP which is described later ( paragraph 4.8.4.)
To choose the mode, press button 4
At each lighting, the stove automatically sets to the
operating mode that it was in the last time it shut
down.
4.9.2. Manual mode
In this mode you can only vary the thermal power provided by choosing
the flame power.
Button 4 of the remote control is used to select MANUAL mode. On
the display this is indicated by the message MAN and the flame
symbol. In this mode, button 5 is used to adjust the 5 heating powers
of the stove.
Press the upper part of button 5 to increase power. Press the lower
part to decrease power. This variation is indicated by the bars located
above the flame symbol. Upon reaching the 5th power level, the
message MAX appears under the flame symbol. This indicates that
maximum performance of the stove has been reached.
In this operating mode, the flame symbol is completely on.
4.9.2.1.
Changing from manual to automatic mode
To change from MANUAL to AUTOMATIC operating mode, just press
the button no. 4 . The message MAN will go off and the message
AUTO will come on. The flame power indicators and the flame icon will
disappear. The numerals will come on for setting the desired
temperature (icon 8)
4.9.3. Automatic mode
Whereas MANUAL mode lets you simply choose the thermal power
provided with no variation of operation over time, AUTOMATIC
mode lets you set a temperature to be reached in the room. In
this operating mode the stove will automatically vary the thermal
power provided so as to keep the temperature in the room
constantly at the set value.
Press button 4 on the remote control to select AUTOMATIC mode.
This will be shown on the display by the message AUTO. In this
4
5
4
5
MAX