MCZ PowerBox COMPACT - Manual (Page 29)

Chapter 4
INSTALLATION AND USE MANUAL
page
29
Operation Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
4.5.2. General characteristics of the LCD remote control
The stoves which are equipped with the ACTIVE SYSTEM combustion
control device are controlled mainly by a remote control or in an
emergency from the small rear panel.
The LCD remote control lets you take full advantage of all the features
of the stove, adjust all operating parameters, set the timer, but most of
all to continuously monitor the room temperature so as to suitable
control the stove's operation.
In fact, the temperature sensor is built right into the remote control.
This allows more precise measurement of the temperature in the room
to be heated wherever the user wants, and without the inconvenience
and limitations of wired thermostats.
The remote control has back-lighting which is activated by simply
pressing a key.
Keep the remote control away from direct heat and
water.
It is advisable to keep it out of the reach of children.
The remote control should always be kept near the
stove (within a radius of 5 m) so that correct room
temperature values are transmitted. If the stove does
not receive any input from the remote control for at
least three hours, it will start emitting periodic
acoustic signals to inform the user that the remote
control is too far away or that the batteries are dead.
The display of the emergency panel will show the
alarm A10. In this alarm condition, the stove will
continue working. To eliminate the alarm, just move
the remote control nearer to restore normal operating
conditions.
4.5.3. Type of batteries and replacement
The batteries are housed in the lower part of the device at the support
base.
Operation requires 3 AAA batteries 1.5 V.
Via icon no. 4, the remote control informs the user when the batteries
are nearly dead. If the icon showing an empty battery appears, it
means that the batteries are nearly dead and that the remote control is
about to shut off.
If the remote control is off due to dead batteries, it is
only possible to control the equipment via the front
panel (see paragraph 4.5). Only a few essential
functions remain active during emergency operation:
power on, power off and manual adjustment of three
levels of power.
The batteries provided have a limited lifespan to
allow first lighting of the stove and for the user to
learn how to use the device.
It is advisable to replace the batteries after the first
lighting. It is also advisable to keep a stock of reserve
batteries in the home.
Position of the room temperature probe
Dead battery indicator