MCZ PowerBox COMPACT - Manual (Page 22)

Chapter 3
INSTALLATION AND USE MANUAL
page
22
Installation and fitting Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
3.12. COMPENSATION FRAME ASSEMBLY
Once the cladding and/or the part in plasterboard are complete, install
the previously removed compensation frame( chap. 3.4)
This frame is designed to finish and cover the crack that is formed
between the metal structure of the unit and the wall.
To assemble the frame, just open the PowerBox door, fit the frame as
shown in the figure and use the four screws provided to fix it onto the
stiles of the structure, inside the profile of the door.
3.13. INSTALLATION OF PELLET CHUTE DOOR
(LINK)
The door can be rotated by 180° depending on whether it is positioned
on the left or right side of the cladding. In fact, the door frame is
perfectly symmetric with regard to the holes for fastening the door to
the hood, so it can be rotated as needed.
3.13.1. Door assembly POWERBOX LINK
Once the tube is connected as described in paragraph 3.5, proceed
as follows:
• Fasten the door to the hood with the four screws. Use the four
holes on the frame of the door marked (A).
• The holes marked on the inner profile of the door (B) are used
to fasten the frame of the door to the frame of chute. This
permanently attaches both parts, with the wall of the hood in
the middle.
• It is necessary to make a rectangular hole in the hood at a
height determined by the installation of the unit and how the
tube is positioned. (see chap.3.4 of the manual).
As described above, the door can also be assembled
rotated by 180°, so if it is decided to assemble the
door as the mirror image of the drawing, the holes (A)
and (B) are simply inverted.
3.14. OPENING/CLOSING PELLET DOOR
The door is closed by pressing. Therefore it does not have any handles
or grips.
To open or close the door, press on the upper left corner. This simple
pressure will attach or detach the door from the closing device on the
door frame.
Compensation frame assembly
B
A
B
Fastening of wired door to hood