beautypg.com

Start-up/shutdown from emergency panel – MCZ PowerBox COMPACT User Manual

Page 32

background image

Chapter 4

INSTALLATION AND USE MANUAL

page

32

Operation

Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited

4.8.2.

Note on first ignition

The first attempt at ignition may not be successful,

since the feeder screw is empty and it is not always

able to fill the grate with required amount of pellets

in time to ensure normal ignition

CANCEL THE ALARM CONDITION FROM THE

EMERGENCY PANEL (see paragraph 4.16), REMOVE

PELLETS IN THE GRATE AND REPEAT LIGHTING

After repeated attempts at lighting, if there is no flame even though

pellets are flowing normally, check that the grate is correctly

positioned. It must be placed where it adheres perfectly to its

housing and free of any ash incrustations. If after this check no

abnormalities are found, it means that there may be a problem with the

stove components or that installation may not have been carried out

correctly.

REMOVE THE PELLETS FROM THE BURNER AND

CONTACT AN AUTHORISED MCZ TECHNICIAN.

4.8.3.

Start-up/shutdown from emergency panel

If the remote control is defective or the batteries are dead, you can

temporarily run the stove from the rear emergency panel.
In this configuration, the stove can operate only in manual mode and

with possibility to select from 3 levels of power.

LIGHTING THE STOVE WITHOUT THE REMOTE

CONTROL

To light the stove, place selector “D” to ON. At start-up the

red LED goes off and the green LED will start flashing until the

start-up phase is complete. At full operating power the green

LED will come on steady.

SELECTING POWER WITHOUT REMOTE CONTROL

You can choose from three levels of heating power:
MIN-MED-MAX (selector “E”)
MINIMA power is the 1st power;
MEDIUM power is the 2nd power;
MAXIMUM power is the 3rd power;

SHUTTING DOWN THE STOVE WITHOUT THE REMOTE

CONTROL

To shut down the stove, place selector “D” to OFF.

Once the remote control is working again, remember

to put selector "D" back in the "REMOTE" position.

Otherwise the stove will disregard inputs from the

remote control.

- OFF
- REMOTE

- ON

- MIN
- MED

- MAX

D

E

- OFF
- REMOTE

- ON

- MIN
- MED

- MAX

TEST

- OFF
- REMOTE

- ON

- MIN
- MED

- MAX

TEST