Epson Expression Premium XP-635 Refurbished - Manual (Page 87)

32 bit version of Windows: WINX86
64 bit version of Windows: WINX64
7. Follow the on-screen instructions.
For Windows XP, setup is complete. For Windows Vista and later, check the port configuration.
Checking the Port Configuration - Windows
After setting up the port, check the port configuration if you are using Windows Vista or later and using the
TCP/IP port for printing.
1. Open the devices and printers screen.
❏ Windows 8.1/Windows 8
Desktop > Settings > Control Panel > Hardware and Sound or Hardware > Devices and Printers.
❏ Windows 7
Click start > Control Panel > Hardware and Sound (or Hardware) > Devices and Printers.
❏ Windows Vista
Click start > Control Panel > Hardware and Sound > Printers.
2. Open the devices and printers screen.
❏ Windows 8.1/Windows 8/Windows 7
Right-click the printer icon, and then click Printer properties.
❏ Windows Vista
Right-click the printer icon, and then select Run as administrator > Properties.
3. Click the Ports tab, select Standard TCP/IP Port, and then click Configure Port.
4. Check the port configuration.
❏ For RAW
Check that Raw is selected in Protocol, and then click OK.
❏ For LPR
Check that LPR is selected in Protocol. Enter "PASSTHRU" in Queue name from LPR Settings. Select LPR
Byte Counting Enabled
, and then click OK.
Setting Up a WSD Port – Windows
This section explains how to set up a WSD port for Windows 7/Windows Vista.
Note:
For Windows 8, the WSD port is set up automatically.
The following is necessary to set up a WSD port.
❏ The printer and computer are connected to the network.
❏ The printer driver is installed on the computer.
1. Turn the printer on.
Network Guide
Appendix
87