Epson 440 - Manual (Page 190)

5. After making your changes, exit the default-setting mode by turning off
the printer.
Note:
❑ You may exit the default-setting mode any time by turning off the printer.
Any changes you have made remain in effect until you change them again.
❑ If you want to check the current default settings, enter the default-setting
mode again and print the current settings. The current settings are indicated
with arrows.
Selecting fonts
Your printer has eight built-in character fonts including two EPSON fonts:
EPSON Roman T and EPSON Sans Serif H. (Roman T is similar to the
Times

font; Sans Serif H is similar to Helvetica

. )
To select a font, enter the default-setting mode. See “Changing the default
settings” on page A-7.
Note:
Font selections you make with your software override your printer’s control panel
selections. For best results, use your software to select fonts.
The table below shows the available fonts.
Fonts Sample
EPSON Courier
EPSON Roman T
EPSON Sans Serif H
EPSON Roman
EPSON Sans Serif
EPSON Prestige
EPSON Script
Draft
L
Easter2 Ref. Guide
Rev.b
A5 size Appendix A
05-28-97 DR, pass 0
A-8 Using the Printer with DOS