Epson 440 - Manual (Page 156)

Paper handling
Paper does not feed properly from the sheet feeder.
Cause What to do
Too many sheets are loaded
in the sheet feeder. Take the paper stack out of the feeder,
remove some sheets, and reload the
stack. Before you load paper, check the
amount of paper you can load in the
sheet feeder. See Chapter 7.
The edge guides are not set
correctly. Adjust the guides against the stack of
paper. See “Loading Paper” in
Chapter 3 or Chapter 5.
Paper is jammed in the paper
path. Turn off the printer and gently pull
out all of the jammed paper. If it tears
and pieces remain inside the printer,
open the printer cover; then remove
any remaining pieces of paper.
The paper stack does not fit
under the edge guide tab
inside the left edge guide. Reload the paper so that it fits under
the edge guide tab. See “Loading
Paper” in Chapter 3 or Chapter 5.
The paper is curled or folded. Use flat, undamaged paper.
The paper is old or creased. Use only new, smooth sheets of paper.
The paper’s size is not
compatible with the printer. Use paper that meets the paper
requirements for this printer. See
“Paper” in Appendix C.
L Easter2 Ref. Guide
Rev.b
A5 size Chapter 10
05-28-97 DR, pass 0
10-16 Troubleshooting