Magnum Energy MS-G Series - Manual (Page 11)

©
2015 Sensata Technologies Page 3
Introduction
1.3 Features and Benefi ts
The MS-G Series inverter/chargers are designed to allow easy access to wiring, circuit breakers,
and controls. Their die cast baseplate with one-piece aluminum cover ensures maximum durability
with minimum weight, as well as a cooler, more effi cient operation.
Note: While not pictured, the MS2000-G inverter/charger has the same features as those listed
in this section (and as shown in Figures 1-1 through 1-3).
The front of the MS-G inverters are equipped with the following (refer to Figures 1-1 and 1-2):
1
Power ON/OFF Switch – a momentary pushbutton switch that alternately turns the
inverter on or off.
2
Status LED Indicator – this green LED illuminates to provide information on inverter
or charger operation.
3
Stack/Accessories Connection Port (red label) – a RJ11 port that allows series-
stacking, and accepts the optional RSAs (Remote Switch Adapters) for remote on/off
switch operation.
Info: The series-stacking capability—which allows two units to provide 120/240 VAC
output—is only available on the MS4024-G inverter/charger. See the ME-SSI owner’s
manual (PN: 64-0009) for additional information on series stacking.
4
Network Connection Port (green label) – a RJ11 port that accepts optional network
capable accessories (i.e., Auto Gen Start or Battery Monitor).
5
Remote Connection Port (blue label) – a RJ11 port that allows an optional remote
control to be connected.
6
Battery Temperature Sensor Connection Port (yellow label) – a RJ11 port that
accepts the remote Battery Temperature Sensor (BTS).
Figure 1-1, Power Switch, Status LED, and Accessory Connection Ports
1
2
3
4
5
6
Power ON/OFF Switch
Status LED Indicator
(charging/inverting)
Stack/Accessories Connection Port
(red label – RJ11 connection)
Network Connection Port
(green label – RJ11 connection)
Remote Connection Port
(blue label – RJ11 connection)
Battery Temperature Sensor Port
(yellow label – RJ11 connection)