SMA STP 15000TL Installation - Manual (Page 72)

Messages SMA Solar Technology AG
72 STP20TLHE-IA-IEN122222 Installation Manual
3801 < DC overcurrent >
< Check generator >
On the DC side of the inverter, an
overcurrent has been detected and the
inverter has briefly interrupted feed-in. If this event occurs frequently:
• Check the design and the circuitry of
the PV array.
3901 …
3902 < Waiting for DC start conditions >
< Start cond. not met >
The input power or input voltage of the
PV modules is insufficient for feeding into
the electricity grid. • Wait for more irradiation.
• If necessary, increase the voltage limit
for the start of feed-in if the event occurs
frequently in the morning (parameter
setting via communication).
• If this event recurs at medium
irradiation, check the PV plant design
and correct the circuitry of the PV array.
6001 …
6438 < Self diagnosis > or
< Interference device > • Contact the SMA Service Line
(see Section 15 "Contact" (page 94)).
6501 …
6511 < Self diagnosis > or
< Overtemperature >
The inverter switches off due to excessive
temperature. • Ensure sufficient ventilation.
• Check heat dissipation, as described in
Section 9.2 "Checking Heat
Dissipation" (page 61).
6603 …
6604 < Self diagnosis > or
< Overload > • Contact the SMA Service Line
(see Section 15 "Contact" (page 94)).
6701 …
6702 < Comm. disturbed >
A fault has occurred in the internal
communication of the inverter. However,
the inverter continues feeding into the
grid. If this event occurs frequently:
• Contact the SMA Service Line
(see Section 15 "Contact" (page 94)).
6801 …
6802 < Self diagnosis > or
< Input A defective > • Contact the SMA Service Line
• (see Section 15 "Contact" (page 94)).
7001 …
7002 < Sensor fault fan permanently on > • Contact the SMA Service Line
(see Section 15 "Contact" (page 94)).
7008 < Disturbance sensor display
temperature > • Contact the SMA Service Line
(see Section 15 "Contact" (page 94)).
7101 < SD card defective > Re-format the SD card.
• Re-save the files to the SD card.
7102 < Parameter file not found or defective > • Copy the parameter file into the
SD card drive :\PARASET directory.
Event no. Display message and cause Corrective measures