SMA STP 15000TL Installation - Manual (Page 24)

Mounting SMA Solar Technology AG
24 STP20TLHE-IA-IEN122222 Installation Manual
3. Hang the inverter in the back panel in such a way
that the enclosure of the inverter lies flush with the
back panel.
– For two people to transport the inverter, use the
recessed grips at the bottom and at the same
time hold the upper edge of the enclosure lid.
– For transport by crane, you can attach 2 ring
bolts to the top of the inverter
(see A: M10, diameter = 10 mm). To do this,
remove the filler-plugs and screw in the ring
bolts as far as they will go.
4. If necessary, remove the ring bolts after transport
and re-attach the filler-plugs.
5. Loosen all 6 captive screws of the lower enclosure
lid.
6. Lift and remove the lower enclosure lid from below.
A