SMA SUNNY HOME MANAGER Installation - Manual (Page 65)

SMA Solar Technology AG 9 Troubleshooting
Installation Manual HoMan-IA-en-17 65
9. Enter the serial number of the Sunny Home Manager in the PIC field. Enter the registration ID
of the Sunny Home Manager in the RID field.
10. Select [Identify].
☑ Sunny Portal checks whether the serial number and registration ID correspond to the
connected Sunny Home Manager.
✖ The PV System Setup Assistant cannot find any Sunny Home Manager with the serial
number and registration ID?
An error has occurred.
• Rectify the error (see Section 9 "Troubleshooting", page 52).
11. Select [Next].
12. Select [Finish].
9.8 Resetting the SMA Radio-Controlled Socket to Default Settings
You must reset the SMA radio-controlled socket to default settings in the following cases:
• You wish to operate the SMA radio-controlled socket in a different system.
• You wish to reset the measured values of the SMA radio-controlled socket.
Procedure
1. Unplug the SMA radio-controlled socket from the outlet and then plug it back in.
☑ The upper horizontal LED glows red for approximately ten seconds.
2. As soon as the vertical LEDs are glowing green, press and hold the touch key for five seconds.
Do not release the key until the upper horizontal LED is glowing red.
☑ The NetID is reset to 0.
☑ The measured values are reset.
☑ The system password is reset to the standard password of 1111 for the user group
Installer.
Reading off the serial number and registration ID
You can read off the serial number and the registration ID at the following locations:
• On the type label at the back of the Sunny Home Manager
• On the cover of the supplied CD