SMA SUNNY HOME MANAGER Installation - Manual (Page 32)

6 Installation SMA Solar Technology AG
32 HoMan-IA-en-17 Installation Manual
6.3 Checking the BLUETOOTH Connection at the Designated
Mounting Location
If the Sunny Home Manager is to communicate with other SMA devices via BLUETOOTH, e.g. with
SMA radio-controlled sockets, you must check the BLUETOOTH connection at the designated
mounting location.
Requirements:
☐ The same NetID must be configured for all BLUETOOTH devices and on the
Sunny Home Manager (see Section 5 "Preparing for Mounting and Commissioning of the
Sunny Home Manager", page 28).
☐ The BLUETOOTH PV system must be commissioned (see Section 5.1 "Preparing for
BLUETOOTH Communication", page 28).
Procedure
1. Supply the Sunny Home Manager with voltage via the plug-in power supply
(see Section 7.6.1).
☑ After approx. two minutes, the BLUETOOTH LED is glowing blue. The connection to the
BLUETOOTH devices is good.
✖ The BLUETOOTH LED is flashing blue?
The BLUETOOTH connection is critical.
• If possible, select a different mounting location and check the connection.
• If no other mounting location is possible, use a BLUETOOTH Repeater or an
SMA radio-controlled socket. This will extend the wireless range of your BLUETOOTH
network.
2. Pull the plug-in power supply out of the outlet.
3. Unplug the DC plug of the plug-in power supply from the Power terminal of the
Sunny Home Manager.