beautypg.com

Starting the test run, Graphically testing the first part 1.4 – HEIDENHAIN TNC 640 (34059x-04) ISO programming User Manual

Page 61

background image

Graphically testing the first part

1.4

1

TNC 640 | User's Manual for DIN/ISO Programming | 3/2014

61

Starting the test run

Press the

RESET + START soft key: The TNC

simulates the active program up to a programmed

break or to the program end
While the simulation is running, you can use the

soft keys to change views
Press the

STOP soft key: The TNC interrupts the

test run

Press the

START soft key: the TNC resumes the

test run after an interruption.

Further information on this topic

Running a test run: See "Test Run", page 533
Graphic functions: See "Graphics ", page 522
Adjust the simulation speed: See "Speed of the Setting test

runs", page 523