HEIDENHAIN TNC 640 (34059x-04) ISO programming - Manual (Page 184)

Programming: Tools
5.2 Tool data
5
184
TNC 640 | User's Manual for DIN/ISO Programming | 3/2014
Calling the tool management
The tool management call can differ as described
below. Refer to your machine manual.
To select the tool table, press the TOOL TABLE
soft key.
Scroll through the soft-key row
Select the tool management soft key: The TNC
goes into the new table view (see figure at right)
In the new view, the TNC presents all tool information in the
following four tabs:
Tools: Tool specific information
Pockets: Pocket-specific information
Tooling list: List of all tools in the NC program that is selected in
the Program Run mode (only if you have already created a tool
usage file, See "Tool usage test", page 181)
T usage order: List of the sequence of all tools that are inserted
in the program selected in the Program Run mode (only if you
have already made a tool usage file, See "Tool usage test",
page 181)
You can edit the tool data only in the form view,
which you can activate by pressing the
FORM FOR
TOOL soft key or the ENT key for the currently
highlighted tool.
If you use tool management without a mouse, then
you can activate and deactivate functions with the
"-/+" check box.