Tool usage file, Machine settings 18.3 – HEIDENHAIN TNC 640 (34059x-04) ISO programming User Manual

Page 555

Machine settings 18.3

TNC 640 | User's Manual for DIN/ISO Programming | 3/2014

555

If you assign the access right

Query to a connection and access is

implemented from this address, the TNC opens a pop-up window.

You must permit or deny external access in the pop-up window:

External access

Permission

Yes

Permit once

Always

Permit continuously

Never

Deny continuously

Deny once

In the overview list an active connection is shown

with a green symbol.
Connections without access rights are shown gray in

the overview list.

Tool usage file

The tool usage test function must be enabled by

your machine manufacturer. Refer to your machine

manual.

With the MOD function

Tool usage file you can select whether the

TNC never, once, or always uses a tool usage file.
To generate a tool usage file:

In the MOD menu select the

Machine settings group

Select the

Tool usage file menu

Select the desired setting for the

Program Run, Full Sequence/

Single Block and Test Run operating modes
Press the

APPLY soft key

Press the

OK soft key