HEIDENHAIN TNC 640 (34059x-04) ISO programming - Manual (Page 576)

MOD functions
18.13 Configure HR 550 FS wireless handwheel
18
576
TNC 640 | User's Manual for DIN/ISO Programming | 3/2014
18.13 Configure HR 550 FS wireless
handwheel
Application
Press the SET UP WIRELESS HANDWHEEL soft key to configure
the HR 550 FS wireless handwheel. The following functions are
available:
Assigning the handwheel to a specific handwheel holder
Setting the transmission channel
Analyzing the frequency spectrum for determining the optimum
transmission channel
Select transmitter power
Statistical information on the transmission quality
Assigning the handwheel to a specific handwheel
holder
Make sure that the handwheel holder is connected to the
control hardware.
Place the wireless handwheel you want to assign to the
handwheel holder in the handwheel holder
Press the MOD key to select the MOD function
Scroll through the soft-key row
Select the configuration menu for the wireless
handwheel: Press the
SET UP WIRELESS
HANDWHEEL soft key
Click the
Connect HR button: The TNC saves the
serial number of the wireless handwheel located
in the handwheel holder and shows it in the
configuration window to the left of the
Connect
HR button
To save the configuration and exit the
configuration menu, press the
END button