HEIDENHAIN TNC 620 (81760x-02) ISO programming User Manual

Page 278

Programming: Subprograms and program section repeats

8.4

Any desired program as subprogram

278

TNC 620 | User's ManualDIN/ISO Programming | 2/2015

Call with SELECT PROGRAM and CALL SELECTED PROGRAM

Use the function

%:PGM to select any program as a subprogram

and call it at another position in the program. The control runs

the called program from the position where it was called in the
program with

%<>%.

The

%:PGM: function is also permitted with string parameters, so

that you can dynamically control program calls.
To select the program, proceed as follows:

To select the functions for program call, press the

PGM CALL key
Press the

SELECT PROGRAM soft key for the TNC

to start the dialog for defining the program to be

called.
press the

SELECT FILE soft key for the TNC to

display a selection window in which you can select
the program to be called. Confirm with the

END

key

To call the selected program, proceed as follows:

To select the functions for program call, press the

PGM CALL key
Press the

CALL SELECTED PROGRAM soft key for

the TNC to call the previously selected program
with

%<>%