HEIDENHAIN CNC Pilot 4290 V7.1 Description of B and Y axes - Manual (Page 63)

HEIDENHAIN CNC PILOT 4290 63
1
.1
1
DIN PLUS (Y Axis): Milling Cy
cles
Engrave in XY plane G803
G803 engraves character strings aligned linearly in the YZ plane. The
text to be engraved is entered in the “ID” box as a character string.
Diacritics and special characters that you cannot enter in the DIN
editor can be defined, character by character, in NS. If text is defined
in “ID” and a character is defined in “NS,” the text is engraved before
the character.
G803 starts engraving from the starting position or from the current
position, if no starting position is defined.
Example: If a character string is engraved with several calls, define the
starting position in the first call. All other calls are programmed without
a starting position.
Character table: see the User’s Manual.
Parameters
ID
Text. Text to be engraved ()
NS Character number. ASCII code of the character to be
engraved
X Starting diameter (diameter dimension)
Y Starting point
Z Milling floor. Z position, infeed depth during milling.
K Retraction plane. Z position retracted to for positioning.
H Font height. Height of the characters in [mm]
W Position angle of the character string with linear alignment.
Example: 0° = Vertical characters: the characters are aligned
in sequence in positive X direction
E Distance factor. The distance between the characters is
calculated according to the following formula: H / 6 * E
F Available as of software version 625 952-05.
Approach feed factor (feed rate = current feed rate * F)