HEIDENHAIN CNC Pilot 4290 V7.1 Description of B and Y axes - Manual (Page 28)

28
1
.5 DIN PLUS: Cont
ours in the XY Plane
Rectangle G375 Geo
G375 defines a rectangle in the XY plane.
Eccentric polygon G377 Geo
G377 defines the contour of an eccentric polygon in the XY plane.
Parameters
X
Center of rectangle (radius)
Y Center of rectangle
K Length of rectangle
B (Height) width of rectangle
R Chamfer/rounding (default: 0)
„ R>0: Radius of rounding arc
„ R<0: Chamfer width
A Angle to X axis (default: 0°)
P Depth/height (default: “P” from G308)
„ P<0: Pocket
„ P>0: Island
I Area diameter (as cutting limit)
„ No entry: “X” from section code
„ “I” overwrites “X” from section code
Parameters
X
Center point of polygon (radius)
Y Center point of polygon
Q Number of edges (Q >= 3)
A Angle to X axis (default: 0°)
K Edge length
„ K>0: Edge length
„ K<0: Inside diameter
R Chamfer/rounding—default: 0
„ R>0: Radius of rounding arc
„ R<0: Chamfer width
P Depth/height (default: “P” from G308)
„ P<0: Pocket
„ P>0: Island
I Area diameter (as cutting limit)
„ No entry: “X” from section code
„ “I” overwrites “X” from section code