HEIDENHAIN PT 855 for Milling - Manual (Page 95)

II - 3 Encoders and Measured Value Display
POSITIP 855 Technical Information 93
Adapting the encoders
Definition of the coordinate axes: P48.*
Axis not displayed; no axis (Off): P48.* = 0
Axis is a linear axis (linear): P48.* = 1
Axis is a rotary axis (rotary): P48.* = 2
You can define separately for each axis whether the encoder
signals are counted positive or negative in positive direction
of traverse.
Counting direction of the encoder signals: P30.*
Positive counting direction: P30.* = 0
Negative counting direction: P30.* = 1
Monitoring of:
• Cables and connectors
• Traversing speeds
• Measuring signal
Encoder monitoring: P45.*
Encoder monitoring (Off): P45.* = 0
Encoder monitoring (On): P45.* = 1