HEIDENHAIN PT 855 for Milling - Manual (Page 89)

II - 2 Operating Parameters
POSITIP 855 Technical Information 87
Transferring operating parameters over the data interface
You can archive the operating parameters on the FE 401 B Floppy
Disk Unit or a PC and read them into the POSITIP again whenever
required. For further information on the data interface and data
transfer, see chapter II - 4.
Preparation
ä Access the operating parameters as described above.
ä Go to the second soft-key level.
To read out parameters
ä Enter the program number under which you wish to save the
operating parameters.
ä Press the
Param. Output
soft key
.
POSITIP reads out all operating parameters.
To download parameters
ä Enter the program number under which the operating
parameters are stored on the diskette.
ä Press the
Param. Input
soft key
.
POSITIP replaces all operating parameter settings in its
memory with those on the diskette.
Fig. 39: The POSITIP screen for transfer of
operating parameters