HEIDENHAIN PT 855 for Milling - Manual (Page 91)

II - 2 Operating Parameters
POSITIP 855 Technical Information 89
List of operating parameters
Parameter Page Function and Numerical
allowed entries entry *)
P1 mm/inch 97 Dimensions in millimeters: mm 0 P1 ...............
Dimensions in inches: inch 1
P3.1 Radius/Diameter 1 97 Radius display 0 P3.1 ............
P3.2 Radius/Diameter 2 Diameter display 1 P3.2 ............
P3.3 Radius/Diameter 3 P3.3 ............
P3.4 Radius/Diameter 4 P3.4 ............
P6 Axis combination 97 No axis combination: off 0 P6 ...............
1+4 displayed on 1 1 ...................
2+4 displayed on 2 2 ...................
3+4 displayed on 3 3 ...................
1–4 displayed on 1 4 ...................
2–4 displayed on 2 5 ...................
3–4 displayed on 3 6
P8 Angle format 97 Decimal display: Degrees 0 P8 ...............
Degrees/Minutes/Seconds 1
P9.1 Angle counting 1 97 360° 0 P9.1 ............
P9.2 Angle counting 2 +/– 180° 1 P9.2 ............
P9.3 Angle counting 3 +/– ¥° 2 P9.3 ............
P9.4 Angle counting 4 P9.4 ............
P11 Scaling factor on 79 Scaling factor inactive: off 0 P11 .............
Scaling factor active: on 1
P12.1 Scaling factor 1 79 Scaling factor P12.1 ..........
P12.2 Scaling factor 2 0.1 bis 9.999 99 1.0 P12.2 ..........
P12.3 Scaling factor 3 P12.3 ..........
P12.4 Scaling factor 4 P12.4 ..........
P23 Display freeze 104 Ignore signal: off 0 P23 .............
Influence position display by Stop display: concrnt. 1
signal for measured-value output Freeze display: frozen 2
P25 Stylus diameter – 0.001 to 999.999 [mm] 6.0 P25 .............
P26 Stylus length – –999.999 to 999.999 [mm] 0.0 P26 .............
P30.1 Counting direction 1 93 Positive counting direction 0 P30.1 ..........
P30.2 Counting direction 2 with positive traverse direction P30.2 ..........
P30.3 Counting direction 3 Negative counting direction 1 P30.3 ..........
P30.4 Counting direction 4 with positive traverse direction P30.4 ..........
P31.1 Signal period 1 94 Signal period of linear encoder 20 P31.1 ..........
P31.2 Signal period 2 95 (see Operating Instructions P31.2 ..........
P31.3 Signal period 3 for encoder) P31.3 ..........
P31.4 Signal period 4 P31.4 ..........
P32.1 Linear subdivision 1 94 Linear subdivision of 20 P32.1 ..........
P32.2 Linear subdivision 2 95 encoder signals P32.2 ..........
P32.3 Linear subdivision 3 P32.3 ..........
P32.4 Linear subdivision 4 P32.4 ..........
*) Standard factory settings are in bold italic type