HEIDENHAIN PT 855 for Milling - Manual (Page 88)

II - 2 Operating Parameters
86 Technical Information POSITIP 855
Operating Parameters
Operating parameters adapt the POSITIP to the machine.
They are identified with the letter P, a three-digit number and a
name.
Axis-specific operating parameters
Some parameters must be entered separately for each axis. Such
parameters are identified in the following descriptions with
an asterisk (*).
Example: Operating parameter for the counting direction: P30.*
For this parameter you enter the counting direction separately for
each axis in parameters P30.1, P30.2, P30.3 and P30.4.
Factory settings
The factory settings for the operating parameters in the overview
on the next pages are set in bold italic type.
Numerical input, dialog input
The current setting of an operating parameter is shown in plain
language under the parameter designation in the on-screen
operating parameter list. In addition, each parameter setting has a
number in the input line at the top. These numbers are transferred
when you read out the operating parameters over the data
interface.
To access the operating parameters
ä Press MOD.
ä Go to the soft key row containing
Code Number
.
(soft key with the key symbol).
ä Press the soft key
Code Number
ä Enter the code number 95148.
ä Confirm with ENT.
ä Display the operating parameters one after the other with the
vertical arrow keys; or
ä Go directly to an operating parameter:
Press GOTO, enter the parameter number and
confirm with ENT.
To change parameter settings
Operating parameter settings can be changed by selecting the
new setting or entering a numerical value:
ä Select a new setting: Press the horizontal arrow key.
or
ä Enter a numerical value directly and confirm your entry with
ENT.
The horizontal arrow key has no function with parameters
which only allow direct numerical entry.
II - 2
Fig. 38: Example of operating parameters