HEIDENHAIN PT 855 for Milling - Manual (Page 93)

II - 2 Operating Parameters
POSITIP 855 Technical Information 91
List of operating parameters
Parameter Page Function and Numerical
allowed entries entry *)
P60.0 Switching output 0 108 Off 0 P60.0 ..........
P60.1 Switching output 1 Assigned to axis 1 1 P60.1 ..........
P60.2 Switching output 2 Assigned to axis 2 2 P60.2 ..........
P60.3 Switching output 3 Assigned to axis 3 3 P60.3 ..........
P60.4 Switching output 4 Assigned to axis 4 4 P60.4 ..........
P60.5 Switching output 5 P60.5 ..........
P60.6 Switching output 6 P60.6 ..........
P60.7 Switching output 7 P60.7 ..........
P61.0 Switching range 0 108 Enter switching range 0.0 P61.0 ..........
P61.1 Switching range 1 symmetrically about zero P61.1 ..........
P61.2 Switching range 2 in [mm] P61.2 ..........
P61.3 Switching range 3 P61.3 ..........
P61.4 Switching range 4 P61.4 ..........
P61.5 Switching range 5 P61.5 ..........
P61.6 Switching range 6 P61.6 ..........
P61.7 Switching range 7 P61.7 ..........
P69 Triggering signal 108 Mode 1 (signal delay 80 ms) 0 P69 .............
Mode 2 (signal delay 5 ms) 1
P81.1 16/40µA switchover 1 92 16 µA encoder signal 0 P81.1 ..........
P81.2 16/40µA switchover 2 40 µA encoder signal 1 P81.2 ..........
P81.3 16/40µA switchover 3 P81.3 ..........
P81.4 16/40µA switchover 4 P81.4 ..........
P83 Sleep delay – Screen saver starts after P83 .............
Screen saver (periodically 5 to 98 [min] 15 ...................
reverses the screen image) No screen saver 99
P88 Rot. direction bolt circle – Positive counterclockwise: P88 .............
Define direction of rotation for Normal 0 ...................
bolt circle graphics Positive clockwise: Inverse 1
P89 Mirroring graphics – No mirroring: Off 0 P89 .............
Mirror coordinate axes in Mirror the vertical axis: Ver. 1 ...................
bolt circle graphics Mirror the horizontal axis: Hor. 2 ...................
Mirror both axes: Ve+Ho 3
P91 Distance-To-Go – Graphic positioning aid: Graphic 0 P91 .............
In
DISTANCE-TO-GO
mode, Tool position: Actual value 1 ...................
display either graphic positioning aid ...................
or actual position of tool
P92
Feed rate display – Feed rate not displayed: Off 0 P92 .............
Display feed rate F in status line Feed rate displayed: On 1 ...................
at bottom of screen
P96
Data output probing 104 No measured value output: Off 0 P96 .............
With measured value output: On 1
P98 Dialog language – First language, e.g. German 0 P98 .............
Second language, e.g. English 1
P99 Counter application – Milling machine: Milling 0 P99 .............
Lathe: Turning 1
*) Standard factory settings are in bold italic type
Operating parameters P 100 to P 122 are listed on page 88.