Grass Valley Ignite SDC - Manual (Page 99)

Ignite SDC/HDC Robotic Camera Instruction Manual 99
Menu Selections
Protocol Menu
The PROTOCOL menu is shown in Figure 70 . Menu selections are
described in Table 50 .
CAUTION Changing the protocol to anything other than 4, will cause to camera block to
lose communication with the pan/tilt head, SHOT Director, and Ignite system.
If you lose communication, you must reset the protocol to 4 using the con-
trols and indicators on the back of the camera block.
Figure 70. PROTOCOL Menu
Table 50. PROTOCOL Menu Selections
Selection Description
PROTOCOL [1 to 4]
For selecting the remote control communication system in accordance
with the system connected.
1: Information camera communication protocol (EIA422).
2: Information camera communication protocol (EIA232). For connecting a
PC.
3: Convertible PC control protocol (EIA422).
4: Convertible PC control protocol (EIA232). For connecting the pan/tilt
head (baud rate fixed at 9600 bps).
The protocol is actually switched after the power has been turned off and
back on.
PROTOCOL
PROTOCOL
:1
** **
8492_64_r0