Grass Valley Ignite SDC - Manual (Page 53)

Ignite SDC/HDC Robotic Camera Instruction Manual 53
Menu Selections
G/L, Color Bar Settings
Figure 26. G/L Color Bar Setting Submenu
Detail Settings
Figure 27. Detail Setting Submenu
Table 11. G/L Color Bar Settings
Selection Description
H Phase
(-206 to +49) Horizontal phase can be adjusted when a genlock signal is
supplied.
SC Coarse
(1, 2, 3, 4) Coarse adjustment of sub carrier phase can be made when a
genlock signal is supplied.
SC Fine
(-511 to +511) Fine adjustment of sub carrier phase can be made when a
genlock signal is supplied.
Color Bar Set (0.0 IRE, 7.5 IRE) The setup level of color bar can be adjusted.
Color Bar Set2 (0.0 IRE, 7.5 IRE) Set to 0.0 IRE for the SDI card.
Table 12. Detail Settings
Selection Description
Detail
(OFF, Low, High) Contour correction quantity can be selected. Detail set-
tings made using the Horizontal/Vertical Detail Level High/Low setting.
Detail level can be set in horizontal (H) and vertical (V) directions with the
Detail setting at High or
Low.
Whichever the direction, H or V, the set level at High must be at least one
position higher than that
at Low.
H Detail Level H (L+1 to +63)
V Detail Level H (L+1 to +31)
8492_17_r0
8492_21_r0