Grass Valley Ignite SDC - Manual (Page 25)

Ignite SDC/HDC Robotic Camera Instruction Manual 25
Installation Procedures
CAUTION Ensure that the selected mounting surface and hardware can safely support
the weight of a fully assembled unit (approximately 55 lbs (29.95 kg)).
3. If ceiling/inverted mounting is required:
• Remove the L-bracket, rotate it 180 degrees, then re-attach it to the
robotic pan/tilt head.
• Attach a safety wire or chain, that can support the 55 lb (29.95 kg)
weight of the fully assembled unit to one of the bolts in the pedestal
mount flange and secure the other end to a rigid part of the ceiling/
mounting location.
4. Attach the robotic pan/tilt head assembly to the selected mounting
location. Use the four mounting holes in the pedestal mount flange as
shown in
Figure 7 .