Grass Valley Ignite SDC - Manual (Page 47)

Ignite SDC/HDC Robotic Camera Instruction Manual 47
Menu Selections
G/L, Color Bar Setting
Figure 21. GL, Color Bar Setting Submenu
Sharpness (DTL) Setting Overview
Figure 22. Sharpness (DTL) Settings Submenu
Table 6. Color Bar Settings
Selection Description
H Phase
(-206 to +49) Horizontal phase can be adjusted when a genlock signal is
supplied.
SC Coarse
(1, 2, 3, 4) Coarse adjustment of sub carrier phase can be made when a
genlock signal is supplied.
SC Fine
(-511 to +511) Fine adjustment of sub carrier phase can be made when a
genlock signal is supplied.
Color Bar Set (0.0 IRE, 7.5 IRE) The setup level of color bar can be adjusted.
Color Bar Set2 (0.0 IRE, 7.5 IRE) Set 0.0 IRE for the SDI card.
Table 7. Sharpness (DTL) Settings
Selection Description
DTL Select
(Sharpness, Super DTL) If contour correction is not sufficient at the Sharp-
ness position when Detail Level setting is set to Low or High, select the
Super DTL position.
*Neither Sharpness nor Super DTL is valid for contour correction if Detail
Level setting is in the OFF position.
Level
(OFF, Low, High) Detail level can be adjusted when Detail Select setting is
at Sharpness. Super DTL level can be adjusted when it is at Super DTL.
Noise Suppress
(OFF, Low, High) Screen noise can be reduced when Detail Level setting is
at High or Low.
8492_17_r0
8492_18_r0