Grass Valley Ignite SDC - Manual (Page 56)

56 Ignite SDC/HDC Robotic Camera Instruction Manual
Appendix A — SD (NTSC) Camera Block
to Return to Initial Settings
1. Select [Initialize Data] on the main menu screen of each Use Mode.
Press the YES/ABC switch, then the [Initialize Data] screen (
Figure 30 )
shows for about 10 seconds.
Figure 30. Initialize Data Screen
2. Press the YES/ABC switch within about 10 seconds to return to the
initial settings (
Table 15 and Table 16 ), the existing settings are
initialized ( Figure 31 ), and the camera returns to main menu
Figure 31. Data Initialized Screen
3. If the NO/BAR switch is pressed, or if the YES/ABC switch is not
pressed, within about 10 seconds (
Figure 32 ), and the camera returns to
main menu, then the existing settings are not initialized.
Aspect Ratio Aspect ratio can be selected from 16:9 or 4:3.
Fan SW
OFF: Select this setting to stop the fan when its operating sound is found to
be bothersome in a studio or other such environment.
Auto: The temperature is detected automatically, and the fan starts operat-
ing when the temperature exceeds approx. 95 ºF (35 ºC)
Language
English: Menu screen is displayed in English. Japanese: Menu screen is
displayed in Japanese.
Table 14. Other Settings
Selection Description
8492_23_r0
8492_24_r0