Grass Valley Ignite SDC - Manual (Page 108)

108 Ignite SDC/HDC Robotic Camera Instruction Manual
Appendix D — Robotic (Pan/Tilt Head)
Default and Recommended Camera ID and IP addresses
The pan/tilt head and JSC-2300 SHOT Director are factory set to default IP
addresses to allow the units to communicate initially. If you are connecting
multiple cameras, you will need to set each camera, one at a time, before
connecting the next camera to the network, to a unique ID and IP address
using the JSC-2300 SHOT Director.
Table 56 lists the default and recommended IP addresses for cameras 1
through 16.
Note The default IP address for the SHOT Director is 192.168.0.100 with a subnet
mask of 255.255.255.0. If you add SHOT Directors to the network, use IP
addresses 192.168.0.101 through 192.168.0.110.
6 DB15 connector
Camera control cable provides serial control and 12 V dc power from the pan/
tilt head to the camera block.
7 DB9 connector Zoom/focus to lens
8 8” pedestal mount Extension pedestal mount.
9
Zero degree pan
registration mark
Used to verify that the pan/tilt head is pointed in the correct direction prior to
mounting.
10 Camera mount L-bracket Used to mount camera or prompter
Table 56. Default and Recommended IP Addresses for Cameras 1-16
Camera Number/ID Recommended IP Address
CAM16 192.168.0.126 (default)
CAM15 192.168.0.125
CAM14 192.168.0.124
CAM13 192.168.0.123
CAM12 192.168.0.122
CAM11 192.168.0.121
CAM10 192.168.0.120
CAM9 192.168.0.119
CAM8 192.168.0.118
CAM7 192.168.0.117
CAM6 192.168.0.116
CAM5 192.168.0.115
CAM4 192.168.0.114
CAM3 192.168.0.113
CAM2 192.168.0.112
CAM1 192.168.0.111
Table 55. Robotic Pan/Tilt Head Controls and Indicators
Item Name Description