Super gain menu – Grass Valley Ignite SDC User Manual
Page 90

90
Ignite SDC/HDC Robotic Camera Instruction Manual
Appendix C — HD Camera Block
Super Gain Menu
The SUPER GAIN menu is shown in
. Menu selections are
described in
.
Figure 61. SUPER GAIN Menu
Note
These settings are performed when S.GAIN1, S.GAIN2 or S.GAIN3 has been
selected by GAIN SELECT.
Table 42. SUPER GAIN Menu Selections
Selection
Description
MODE
[S.GAIN1, S.GAIN2, S.GAIN3]
For selecting the S.GAIN storage table.
TOTAL GAIN [0 dB to 72 dB]
For displaying the total gain for GAIN, PIX MIX, V MIX and FRAME MIX.
GAIN [0 dB to 36 dB]
For setting the gain increase.
PIX MIX [OFF, +6 dB]
For setting the addition of horizontal pixels ON or OFF.
V MIX [OFF, +6 dB]
For setting the addition of vertical pixels ON or OFF.
FRAME MIX
[OFF, +6 dB to +24 dB]
For setting the gain increase based on accumulation in the CCD image
sensor. This setting does not take effect when MENU SEL is set to FILM
MENU and the 720/60p or 720/59.94p is selected as the FORMAT setting.
H DETAIL LEVEL [00 to 63]
For setting the H DETAIL level.
CRISP [00 to 31]
For setting the noise elimination level of the detail signals.
LEVEL DEPENDENT [0 to 15]
For removing the detail in the dark areas. The higher the number set, the
wider the range in which the detail is removed.
PEAK FREQUENCY [0 to 31]
For setting the H DTL peak frequency.
M GAMMA
[0.35 to 0.75 (DRS OFF)]
[–10 to +10 (DRS ON)]
For adjusting the gamma characteristics.
M PED OFFSET [–200 to +200]
For adjusting the amount of offset in the black level.
R PED OFFSET [–200 to +200]
For adjusting the amount of offset in the R pedestal.
B PED OFFSET [–200 to +200]
For adjusting the amount of offset in the B pedestal.
S. GAIN (1/2)
S. GAIN1
MODE
:S. GAIN1
TOTAL GAIN :42dB
GAIN
:30dB
PIX MIX
:+6dB
V MIX
:+6dB
FRAME MIX
:OFF
H DETAIL LEVEL
:1
CRISP
:00
LEVEL DEPENDENT
:5
PEAK FREQUENCY
:2
S. GAIN (2/2)
S. GAIN1
M GAMMA
:0.50
M PED OFFSET
:+000
R PED OFFSET
:+000
B PED OFFSET
:+000
**
**
**
**
*
8492_53_r0